Mame Cabinet.pdf

LuSiD’s Arcade Flashback

Cabinet Plans

Revision 7

I. Assembly Notes

It’s a lot easier to cut the cut the groove for the T molding before assembling the cabinet.

The 26” edges of the cabinet bottom need T molding, as well as the cabinet sides.

A few edges should be cut at a 45 angle for everything to fit together. These are both

26” edges of the Cabinet Back – Angled section, and one 30” edge of the Control panel

box Back.

All the measurements assume that 5/8” wood is used for the cabinet. If 3/4" wood is

used, the Coin Door should be 26” X 29 ¾”, and the CP Box Sides should be 14 ½” deep.

To change the width of the cabinet to accommodate a wider or narrower monitor or TV,

change all the 26” measurements to the desired width.

II. Assembly Sequence

1. Start by assembling the cabinet bottom.

The kick plates and lower supports create a

support frame for the base of the cabinet.

You’ll end up with something like this:

Bottom View

2. Next turn it over, frame side down, and attach the side panels. With 6 –8 screws

on each side it should hold itself together long enough to attach the top, back and

sides, which should all be recessed about ½” from the edge of the side panels.

3. Assemble the control panel box seperately, and then attach

it to the cabinet. The bottom of the CP box fits inside the

square created by the 4 sides. The Control Panel top is

held on with velcro.

Side view of CP -Box. Front, back &

bottom

4. Cut the hole for you coin door (if you plan on using one) and attach the T molding

to the cabinet before mounting the door on its hinges. Otherwise the T molding

may affect the alignment of the hinges

LuSiD’s Arcade Flashback, Cabinet Design, rev. 7, page 1

Monitor Shelf

(26” X 22”)

Control

Panel

Cabinet Side 1

LuSiD’s Arcade Flashback , Cabinet Design, rev. 7, page 2

= 1 inch

Control Panel Box -Bottom

(30” X 13”)

Control Panel Box - Back – (30” X 5 ½”)

Control Panel Box – Front - (30” X 3 ½”)

Control

Panel

Cabinet Side 2

LuSiD’s Arcade Flashback , Cabinet Design, rev. 7, page 3

= 1 inch

Cabinet Bottom

( 26” X 38” )

Speaker Panel

(below the marquee)

( 26” X 24” )

Cabinet Back

Angled section

(26” X 22”)

Cabinet Back

Top section

( 26” X 18” )

Cabinet Front

Coin Door

( 26” X 30” )

CP box – Side 1

Cabinet Back

Bottom section

( 26” X 18” )

CP Box – Side 2

----------- 14 ¼ “ -------------

LuSiD’s Arcade Flashback , Cabinet Design, rev. 7, page 4

= 1 inch

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: