Clock - Country Curio Clock2.pdf - Woodworking Plans - qqwwee119

Project 12231EZ:

Country Curio Clock

This good-looking clock not only reminds you of the time, it also provides a couple

of shelves to display favorite curios. No fancy joinery is needed here, just butt

joints secured with countersunk screws. Although the joinery may be simple, it’s

plenty sturdy for a small wall clock like this. We hope you enjoy building it and

using it.

We used pine for all parts except the birch plywood dial board. You can purchase

the molding at almost any lumberyard. You can obtain the hand screened enam-

eled metal dial and battery operated quartz movement from a clockmaker’s supply

store.

Country Curio Clock Materials List

Part

Description

Size

No. Req’d

Side

3/4" x 3-1/2" x 24"

Shelf

3/4" x 3-1/4" x 9"

Lower Back

3/4" x 3" x 9"

Upper Back

3/4" x 4" x 9"

Dial Board

1/4" x 9" x 9"

Molding

11/16" x 1-1/8" x 9"

Cleat

1/2" x 3/4" x 2"

Dial*

6" dia.

Movement*

5/8" x 2-1/8" x 2-1/8"

* Obtain parts H and I from a clockmaker’s supply store.

Country Curio Clock Complete

Schematic

Country Curio Clock Step-by-Step

Instructions

Step 1: Cut Stock to Size

1. Select a 52" length of 1" x 8" lumberyard pine (3/

4" x 7-1/4" actual) with limited cups, twists, and

knots to make most of the parts for the projects.

2. Make sure your miter gauge is set at exactly 90

degrees so your crosscuts will be exactly square.

3. Refer to the cutting diagram and crosscut and rip

the stock as needed to get the dimensions shown

in the materials list.

Step 2: Shape the Case Parts

1. Use the grid patterns provided to lay out and mark

the curves on the two sides (A), along with the

curve on the lower back (C) and the upper back

(D).

2. Use a band saw to cut out the curves.

3. Use a file and sandpaper to smooth the sawn

edges.

4. Use the router table and a 1/4" radius roundover

bit to round the front edges of the sides, the front

edges of the three shelves, the bottom front edge

of the lower back, and the top front edge of the

upper back.

5. Use a file and sandpaper to get into the sharp

corners on the upper back curve that the router bit

won’t be able to reach.

Step 3: Assemble the Case Parts

1. Lay out and mark the shelf locations on the two

sides.

2. Use 1-1/4" x #8 flathead wood screws, counter-

sunk to a depth of 1/4", to assemble the case parts

as shown.

3. Add the lower and upper backs in the same man-

ner.

Clock - Country Curio Clock2.pdf

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: