bra dress instructions.pdf

(389 KB) Pobierz
194657324 UNPDF
Vodcast
Episode
37
f e at u r e d P r O J e C t
party dress in an instant
Notes
SupplieS Needed
1 bra (Note: when purchasing a bra for this project, look to see that the back of the
bra is made with similar fabric or trim as the front. Not just with elastic that looks
like a standard bra)
2 ¼ yards of fabric for the body of the dress
Water soluble marker
Dual Duty XP sewing thread
The KIT
CuTTiNG
Swatches
1. Measure the bra band from end to end. Double this measurement for the
width of the front and back panels.
2. For the length of each of the panels, measure from under the bra line to
where you would like the dress hem to fall. Now, add 1” to that measurement,
½” for the hem and ½” for the seam at the top edge of the dress.
3. Cut two panels using the above measurements.
4. Cut two strips 6” wide by 36” long for the straps.
SeWiNG
Special Thanks To
1. At the top of the center back panel, mark a four to ive inch “V”. With a
small straight stitch, stitch around the marking.
2. Cut down the center of the “V”. Fold under twice to the wrong side of the
panel. Stitch securely.
3. Pin the right sides of the front and back panels’ together, stitch and press.
4. Stitch a row of gathering stitches along the top edge of each of the panels.
Gather up about one fourth of the fullness from the panels.
5. Divide the dress panel and the bra into fourths. Lay the wrong side of the
bra on top of the right side of the dress panel, pin at the markings.
6. Set the sewing machine to a three step zigzag and stitch the dress panel
to the bra’s lower band. Pulling the bra band taut as you stitch, drawing in the
balance of the dress’ fullness to it the bra band.
7. Snip the stitches holding the bras straps to the bra and remove them from
the bra.
8. To make the straps, fold each strip of fabric in half lengthwise with right
sides facing. Stitch a small seam, angling at one end and leaving the opposite
end open for turning.
9. Turn the straps right side out and press.
10. Gather the raw ends of each strap and pin to the underside of the bra
where the original strap was connected. Stitch the new straps in place,
securely. Tie around the back of the neck, like a halter.
11. Double check the length of the dress. With the serger, stitch a three thread
rolled hem at the bottom edge of the dress.
SEWING TODAY ®
BUTTERICK AND McCALL’S PATTERNS
194657324.033.png 194657324.034.png 194657324.035.png 194657324.036.png 194657324.001.png 194657324.002.png 194657324.003.png 194657324.004.png 194657324.005.png 194657324.006.png 194657324.007.png 194657324.008.png 194657324.009.png 194657324.010.png 194657324.011.png 194657324.012.png 194657324.013.png 194657324.014.png 194657324.015.png 194657324.016.png 194657324.017.png 194657324.018.png 194657324.019.png 194657324.020.png 194657324.021.png 194657324.022.png 194657324.023.png 194657324.024.png 194657324.025.png 194657324.026.png 194657324.027.png 194657324.028.png 194657324.029.png 194657324.030.png 194657324.031.png 194657324.032.png

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin