FIPUN04GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FIAT

PUNTO

YEAR 04 ﬁ

PETROL

DIESEL

MAKE

MOD.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment near the support of

the battery. Pass the cables through the original rubber sleeve near the brake fluid

reservoir.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the 6 mm 2 WHITE/RED wire located in the multiway connector in the fuse

box.

-31: connect with a ring terminal directly to the car body.

IGNITION WIRE

+15/54: connect to the 2 mm 2 ORANGE wire located in the connector coming out of the

ignition key.

DIRECTION INDICATORS

Connect to the 1 mm 2 PINK wire at the position nr.13 and to the PINK/WHITE wire at the

position nr.12, in the 40 way black connector located in the front part of the fuse box.

ELECTRIC WINDOWS

Controls with mixed polarity

Front window, driver’s side:

cut the 2,5 mm 2 WHITE/RED and VIOLET/YELLOW wires.

Front window, passenger’s side:

cut the 2,5 mm 2 VIOLET/BLACK wire.

These connections should be made in the wiring harnesses coming out of each switches

control.

CENTRAL DOORS LOCKING

Negative controls

Connect to the LIGHT BLUE/WHITE wire at the position nr.34 (lock) and to the LIGHT

BLUE/YELLOW wire at the position nr.24 (unlock) in the 40 way black connector in the

fuse box, under the dashboard driver’s side.

IMMOBILISATION POINT

Fuel pump

Cut the ORANGE bond on the black connector, in the lower part of the relay box located

near the battery.

STARTER

+50: Cut the BROWN wire located in the wiring harness coming out of the ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate.

DOORS SWITCH

Connect to the wires: RED at the position nr.8, WHITE/GREEN at the position nr.16,

GREEN/GREY at the position nr.25, BLUE/VIOLET at the position nr.26, of the 40 way

connector, in the fuse box, under the dashboard driver’s side.

Refer to the fitting diagram nr. 208.

BOOT SWITCH

Connect to the LIGHT BLUE/BLACK wire at the position nr.36 of the 40 way connector, in

the fuse box,under the dashboard driver’s side.

Refer to the fitting diagram nr. 208.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fipun04gbb.doc

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FITTING DIAGRAM NR.208

Diagram for perimetrical connection with separated lines

1N4007 diodes

40 way black connector

LIGHT BLUE/BLACK pos. nr. 36

WHITE/GREEN pos. nr. 16

GREEN/GREY pos. nr. 25

BLUE/VIOLET nr. 26

RED pos. nr. 8

1N4007 diodes

BLEU/PINK

(of the antitheft)

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fipun04gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: