Systemy bezpieczeństwa w BMW E39.pdf

(917 KB) Pobierz
ST036 - X5 cover 0800.qxd
TABLE OF CONTENTS
Subject
Page
MRS III Control Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Seat Occupancy Sensor (SBE) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
200382252.004.png
MULTIPLE RESTRAINT SYSTEM (MRS III)
INTRODUCTION
The X5 is equipped with the Multiple Restraint System (MRS III) which employs the use of
“SMART” technology. Smart technology refers to the control module’s programming which
allows for the deployment of the airbags, in stages, depending on the severity of the
impact. Two stage airbags are used for both the driver and front passenger which allows
for a softer cushioning effect when the bags are triggered at lighter impacts.
The MRS III system is installed in E38/E39 and E46 Sedan vehicles as of 3/99 production
and in E46 Coupes as of 6/99 production.
MRS III control modules are manufactured by either Bosch or Temic. While the functional
operation of both modules are the same. The control modules are not interchangeable from
a replacement standpoint. Always refer to the EPC parts system to ensure that the proper
module is installed in the vehicle.
In addition to the use of two stage airbags for the driver and passenger, the following fea-
tures are also included in the MRS III system:
• The MRS III control module is linked to the K-Bus for coding and diagnosis.
• The MRS III includes a fuel pump cut off feature in the event of an airbag deployment.
• Inert gas generators are now used for all air bags and seat belt tensioners.
•The inert gas is a mixture of hydrogen (13.5%) and oxygen (86.5%).
2
200382252.005.png
COMPONENTS
MRS III CONTROL MODULE
The control module is mounted in the center console area on the driveshaft tunnel below
the center storage box. The X5 will use the TEMIC system that can be recognized by the
green 50 pin connector on the module.
The control module contains the processing electronics (Smart Technology) for triggering of
all air bags and pyrotechnic devices installed in the vehicle. Two electronic deceleration sen-
sors are installed in the module for crash or impact detection.
3
200382252.006.png
COMPONENTS
SATELLITE SENSORS
The satellite sensors are mounted below the driver’s and passenger’s front seats on the
seat frame. The function of the sensors is to detect the severity of side impacts and signal
the MRS III control module, through a pulse modulated signal, in the event of a crash. The
control module uses this input signal along with its internal impact sensor signal to deter-
mine the deployment of the side/head airbags.
As with the control modules, the satellite sensors
are manufacturer specific. The Temic sensors in
the X5 have a three wire connector which will not
interchange with the Bosch sensors. Only two of
the wires are used for the satellite sensor’s opera-
tion. The signal for deployment of the bags is car-
ried over the power wire of the sensor.
4
200382252.007.png 200382252.001.png 200382252.002.png
COMPONENTS
DRIVER’S FRONT AIRBAG
With the MRS III system, the driver’s front airbag becomes a two stage bag similar to the
passenger’s front side bag, introduced on the 1999 model E38/E39s. The complete
assembly is mounted beneath the cover in the center of the steering wheel as with previ-
ous airbags. The assembly now contains the inert gas generator chamber and two ignition
stages (ignitors).
The airbag consists of:
• Accumulator/gas generator
• Two ignition capsules
• Propellant gas - 13.5% hydrogen/86.5%
oxygen
• 64 liter airbag
5
200382252.003.png

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin