Wklejam sposób wejścia w tryb serwisowy do innej pralki Boscha, może komuś pomoże, w nadziei na pomoc w mojej sprawie. Pozdrawiam. Selecting the test program Activate test program: Set program selector switch to OFF position Press and hold the two buttons closest to the dial then turn the program selector counter-clockwise to the first program position. Keep holding the buttons until the display shows P:01 Select test program: Push second button from dial to scroll through tests. -P:01 -> Errors -P:02 -> Safety test -P:03 -> Automatic test sequence -P:04 -> Motor -P:05 -> Variant (not currently used) -P:06 -> Display -P:07 -> Buttons and selector switch -P:08 -> Pressure sensor (not currently used) -P:09 -> Pressure switch -P:12 -> Update (not currently used) -P:13 -> Valves -P:14 -> Buzzer -P:15 -> Pump -P:16 -> Heater -P:17 -> Noise (not currently used) Start test program: Press START/PAUSE button Abort test program: Press second button away from program dial or set program selector to Off position Leave test programs: Switch off device P:01 Errors - Press Start/Pause to enter error feedback loop - Press the second button away from the program dial to scroll through errors sequentially; error counts are displayed for each error - Error descriptions are given on Page 2 of this document P:02 Safety test Sequence: - Water fills to first level - Heater is turned on for 30 seconds P:03 Automatic Test Time/s 4* 6 3 2 3 1 10 1 10 10 90 Valve 2 1 3 1+2 Heater Water level L1 Motor CW rotation Off CCW rotation 50rpm 1150 rpm End of program Pumping X X X * depends on pre-filling level and period until level 1 is reached P:04 Motor Test: Sequence: Reversing - Counter-clockwise drum rotation at 50rpm - Clockwise drum rotation at 50rpm Spinning / Pumping: - Spin speed increases to max. speed - Unbalance detection is disabled - Only catastrophic unbaXXXXX XXXXXmits are checked - Speed reduction is not possible P:06 Display All LEDs and all segments of the LCD display are tested Test program runs automatically Sequence: - Backlight switched off (ME99) - Start LED and options LEDs are activated - Pause - Backlight switched on (ME99) - all LCD/LED segments are activated in particular order - Successive activation of single segments in LCD display P:07 Buttons and selector switch Test: Sequence: Buttons - By pressing a button, the associated LED will light up - By pressing the Select button, the spin sign appears in LCD display (ME99) Selector switch - When selecting each position on the selector switch, the serially numbered positions are displayed in LCD display (Do not rotate PS via OFF, otherwise program abort) P:09 Pressure Switch Sequence: - Pump is turned on until the drum is empty - Valve 1 is turned on until first level is reached - Pressure is displayed P:13 Valves - Each valve and valve combination is tested. - Use the START button to step through the test sequence - each push activates the next valve - Pressure (water level) is shown in the display - program runs automatically until level Nmax is reached or second button from program dial is pressed P:14 Buzzer The buzzer is activated at maximum volume. P:15 Pump The pump is activated and runs a maximum time of 30min unless it is stopped by pressing the second button away from the program dial. P:16 Heater The heater is activated as soon as the water level reaches the heating level and is runs a maximum time of 30min unless it is stopped by pressing the second button away from the program dial. Water temperature is displayed during the program. The NTC can be checked during this test
jozek_i