FIPAL98GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FIAT

MOD. PALIO

YEAR 98 ﬁ

PETROL

DIESEL

MAKE

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the

column of the shock absorber, passengers side.To pass the cables open the

plastic bulkhead under the windshield wiper and use the original rubber provided

of two holes whom one is free. You will find it near the fuse box.

POWER SUPPLY

+ 30: connect to the 3 mm 2 RED wire located in the 1 way black connector, in the

upper right part of the fuse box.

- 31: connect to the 2 mm 2 BROWN wire located in the ground point behind the

left lateral bulkhead, drivers side.

IGNITION WIRE

+ 15/54: connect to the 3 mm 2 ORANGE wire located in the wiring harness and

coming out of the 4 way white connector of the ignition key.

DIRECTION INDICATORS

Connect to the 1,5 mm 2 BLUE and BLUE/BLACK wires located in the wiring

harness and coming out of the multiway white connector in the fuse box, the first

in the upper front part of the fuse box.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the 2 mm 2 WHITE/RED wire.

Front window, passenger’s side:

cut the 2 mm 2 RED/GREEN wire.

Connections are made directly in the wiring harness coming out of the original

switches.

CENTRAL DOORS LOCKING

Negative control signal

Connect to the 1,5 mm 2 BLUE wire (lock) and WHITE wire (unlock) located in the

wiring harness coming out of the rubber grommet of the front door, drivers side.

IMMOBILISATION POINT 1

Fuel pump

Cut the 1,5 mm 2 BROWN/WHITE wire located in the multiway white connector,

the first on the left of the fuse box.

IMMOBILISATION POINT 2

+15 general

cut the 3 mm 2 ORANGE wire located in the wiring harness and coming out of the

3 way white connector of the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, near the original

bonnet stop rubber.

DOORS SWITCH

Connect to the 1 mm 2 WHITE/BLUE wire located in the wiring harness of the 3

way grey connector and coming out of the courtesy lamp.

BOOT SWITCH

Connect to the 1 mm 2 WHITE/RED wire located in the wiring harness of the 2 way

grey connector that comes out of the boots interior lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fipal98gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: