FOMON01GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FORD

MOD. MONDEO YEAR. 01 ﬁ

PETROL

DIESEL

MAKE

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the left

bulkhead that divides the engine compartment from the windshield wiper compartment.

To pass the cables use the original rubber sleeve located on the above mentioned

bulkhead, driver’s side.

POWER SUPPLY

+ 30: Connect to the 4 mm 2 RED wire located in the wiring harness of the general

supply of the fuse box.

- 31: Connect, by means of a cable terminal, to one of the ground terminals located

behind the left lateral panel, driver’s side.

IGNITION WIRE

+ 15/54: Connect to the VIOLET/BLUE wire located in the 10 way white connector in

the upper part of the fuse box.

DIRECTION INDICATORS

Connect to the 1 mm 2 BLUE and BLUE/RED wires located in the wiring harness behind

the sill cover, driver’s side.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the 2 mm 2 WHITE wire directly on the coming out of the motor of the window

located inside the driver’s side door.

Front window, passenger’s side:

cut the 2 mm 2 WHITE wire.

Rear window, driver’s side:

cut the 2 mm 2 WHITE/BLUE wire.

Rear window, passenger’s side:

cut the 2 mm 2 WHITE wire.

All these connections are made directly in the wiring harness under the sill cover,

driver’s side, except for that of the driver’s side window.

CENTRAL DOORS LOCKING Negative control signal

Connect to the 0,5 mm 2 BLACK/GREEN wire (unlock) and BLACK/ORANGE wire (lock)

located in the wiring harness behind the left lateral panel, driver’s side.

IMMOBILISATION POINT 1

Fuel pump

Cut the VIOLET/ORANGE wire located in the wiring harness coming out of the

connector of the inertial switch.

IMMOBILISATION POINT 2

Coil locking

Cut the VIOLET/BLACK wire located in the connector coming out of the coil.

STARTER CUT OFF

+ 50: Cut the GREY/WHITE wire located in the wiring harness coming out of the 14

way green connector, on the connectors holder plate under the dashboard, driver’s

side.

BONNET SWITCH

Install an additional switch on the front headlamp support plate near the bonnet

bumper rubber, driver’s side.

DOORS SWITCH

Connect to the 1 mm 2 WHITE and BLACK/RED wires located in the wiring harness

coming out of the 12 way black connector located in the fuse box. To make this

connection it is necessary to divide the lines by means of two diodes.

BOOT SWITCH

Connect to the 1 mm 2 BROWN/RED wire located in the connector coming out of the

boot lamp or as alternative to the BLACK/ORANGE wire at the same position.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fomon01gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: