DALAC04GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE DAEWOO MOD.

LACETTI

YEAR 04 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the left od the battery. Use the original fairlead

located under the driver’s side wheelhouse.

CENTRAL UNIT POSITION

Position the modular sistems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the big wire located at the entrance of the fuse box.

-31: connect to one of the original ground terminal located behind the driver’s side bulkhead.

IGNITION WIRE

+15/54: connect to the GREEN/RED wire (key in), in the 26 way white connector, on the black

central in the central tunnel, near the posterior ash-tray.

DIRECTION INDICATORS

Connect to the WHITE and BLUE wires in the wiring harness of the 26 way white connector,

on the black central in the central tunnel, near the posterior ash-tray.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the BLUE wire in the wiring harness coming out of the push-button panel, directly inside

the driver’s side door.

Front window, passenger’s side:

cut the LIGHT BLUE wire in the wiring harness coming out of the push-button panel, directly

inside the driver’s side door.

CENTRAL DOORS LOCKING Negative control signal

Connect to the wires: GREEN/WHITE (locking) and YELLOW (unlocking), in the wiring

harness coming out of the connector of the driver’s side door. As alternative it is possible to

find the same wires in the wiring harness coming out of the white connector of the central

located behind the passenger’s side bulkhead.

IMMOBILISATION POINT

Fuel pump

Cut the BLUE wire in the wiring harness located behind the driver’s side sill cover.

STARTER

+50: Cut the YELLOW wire in the wiring harness coming out of the connector of the ignition

key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the VIOLET wire in the wiring harness coming out of the 26 way white connector,

on the black central in the central tunnel, near the posterior ash-tray.

BOOT SWITCH

Connect to the PINK/BLACK wire in the wiring harness coming out of the connector directly in

the lamp of the boot.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

dalac04gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: