A3 2002 petrol YES.pdf

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

AUDI

A3 *

YEAR. 02 ﬁ

PETROL

DIESEL

MAKE

MOD.

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the

ABS bracket. Pass the cables through the rubber sleeve located on the panel that

divides the engine compartment and the passenger’s compartment near the shock

absorber, driver’s side.

CENTRAL UNIT POSITION

Position the modular systems and the modules behind the fuse box, under the

dashboard, driver’s side.

POWER SUPPLY

+30: connect to the 4 mm 2 RED wire located in the general supply wiring of the

fuse box.

- 31: connect with a ground terminal on the left, under the dashboard, driver’s side.

IGNITION WIRE

+15/54: connect to the 2 mm 2 BLACK wire located in a multiway connector in the

central part of the fuse box on the left of the dashboard.

DIRECTION INDICATORS

Connect to the 1,5 mm 2 BLACK/WHITE and BLACK/GREEN wire located under

the lateral left , driver’s side.

ELECTRIC WINDOWS

Negative control signal

The closing is obtained timing at 24s. the GREY wire, at the position nr. 1, in the

light brown connector, behind the left lateral bulkhead, driver’s side.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antitheft/vehicle

Art. 3800 Vehicle Position

GREY/BLACK GREEN/BLACK Pos. nr.2, 11 way black connect., white insert

YELLOW/BLACK ground car body

VIOLET ground car body

ORANGE ground car body

VIOLET/WHITE ground car body

ORANGE/WHITE ground car body

Refer to the diagram nr. 160.

IMMOBILISATION POINT

Fuel pump

Cut the 1,5 mm 2 BLUE/RED wire located in the wiring harness under the left sill

cover, driver’s side.

STARTER

+50: Cut the 1,5 mm 2 BLACK/RED wire located in the wiring harness coming out

of the connector of the ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the BROWN/WHITE wire located in the wiring harness under the

lateral left sill cover going to the rear.

BOOT SWITCH

Connect to the 1 mm 2 WHITE/BLACK wire, at the position nr.4, of the 6 way black

connector behind the door on the left of the boot.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

aua302gbbtr1.doc

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FITTING DIAGRAM N°160

Diagram to connect art. 3800 on

AUDI A3 year 2002

Art. 3800

Compressor group

GREY/BLACK VIOLET

ORANGE

YELLOW/BLACK

VIOLET/WHITE

ORANGE/WHITE

GREEN/BLACK

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

aua302gbbtr1.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: