PS4 PS416-INP-40x h1239g.pdf

Hardware and Engineering

PS416-INP-40x

PS416-OUT-4xx

Digital I/O Card

01/00 AWB27-1239-GB

1st published 2000, edition 01/00,

See revision protocol page II

Author: Werner Albrecht

Editor: Thomas Kracht

Translator: Terence Osborn, David Long

All brand and product names are trademarks

or registered trademarks of the owner

concerned.

translation.

No part of this manual may be reproduced in

any form (printed, photocopy, microfilm or

any otherprocess) or processed, duplicated or

distributed by means of electronic systems

without written permission of Moeller GmbH,

Bonn.

Subject to alteration without notice.

Warning!

Dangerous electrical voltage!

Before commencing the installation

• Disconnect the power supply of the device.

• Ensure that devices cannot be accidentally

restarted.

• Verify isolation from the supply.

• Earth and short circuit.

• Cover or enclose neighbouring units that

are live.

• Follow the engineering instructions (AWA)

of the device concerned.

• Only suitably qualified personnel in accordance

with EN 50 110-1/-2 (VDE 0 105 Part 100) may

work on this device/system.

• Before installation and before touching the

device ensure that you are free of electrostatic

charge.

• The functional earth (FE) must be connected to

the protective earth (PE) or to the potential

equalisation. The system installer is responsible

for implementing this connection.

• Connecting cables and signal lines should be

installed so that inductive or capacitive interfe-

rence do not impair the automation functions.

• Install automation devices and related opera-

ting elements in such a way that they are well

protected against unintentional operation.

• Suitable safety hardware and software

measures should be implemented for the

I/O interface so that a line or wire breakage

on the signal side does not result in undefined

states in the automation devices.

• Ensure a reliable electrical isolation of the low

voltage for the 24 volt supply. Only use power

supply units complying with IEC 60 364-4-41

(VDE 0 100 Part 410) or HD 384.4.41 S2.

• Deviations of the mains voltage from the rated

value must not exceed the tolerance limits given

in the specifications, otherwise this may cause

malfunction and dangerous operation.

• Emergency stop devices complying with

IEC/EN 60 204-1 must be effective in all

operating modes of the automation devices.

Unlatching the emergency-stop devices must

not cause restart.

• Devices that are designed for mounting in

housings or control cabinets must only be

operated and controlled after they have been

installed with the housing closed. Desktop or

portable units must only be operated and

controlled in enclosed housings.

• Measures should be taken to ensure the proper

restart of programs interrupted after a voltage

dip or failure. This should not cause dangerous

operating states even for a short time. If

necessary, emergency-stop devices should be

implemented.

• Wherever faults in the automation system may

cause damage to persons or property, external

measures must be implemented to ensure a safe

operating state in the event of a fault or

malfunction (for example, by means of separate

limit switches, mechanical interlocks etc.).

List of revisions for AWB27-1239-GB

Edition

Page

Description

new

Modification

01/00

1-3

Tables

1-10

Section “PS416-OUT-400/-410”

2-3, 2-9

Figure

2-10, 2-18

Notes about this manual

3-3, 3-4, 3-9

Figure

3-26

Notes about this manual

Overview

About this Manual

General

1-1

PS416-INP-400/-401

2-1

PS416-OUT-400/-410

3-1

Appendix

4-1

Index

5-1

III

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: