Making Plastic Explosives.pdf

Making Plastic Explosives from Bleach by The Jolly Roger

Potassium chlorate is an extremely volatile explosive compound, and has been used

in the past as the main explosive filler in grenades, land mines, and mortar rounds

by such countries as France and Germany. Common household bleach contains a small

amount of potassium chlorate, which can be extracted by the procedure that follows.

First off, you must obtain:

1.A heat source (hot plate, stove, etc.)

2.A hydrometer, or battery hydrometer

3.A large Pyrex, or enameled steel container (to weigh chemicals)

4.Potassium chloride(sold as a salt substitute at health and nutrition stores)

Take one gallon of bleach, place it in the container, and begin heating it. While

this solution heats, weigh out 63 grams of potassium chloride and add this to the

bleach being heated. Constantly check the solution being heated with the

hydrometer, and boil until you get a reading of 1.3. If using a battery hydrometer,

boil until you read a FULL charge.

Take the solution and allow it to cool in a refrigerator until it is between room

temperature and 0øC. Filter out the crystals that have formed and save them. Boil

this solution again and cool as before. Filter and save the crystals.

Take the crystals that have been saved, and mix them with distilled water in the

following proportions: 56 grams per 100 milliliters distilled water. Heat this

solution until it boils and allow to cool. Filter the solution and save the

crystals that form upon cooling. This process of purification is called "fractional

crystallization". These crystals should be relatively pure potassium chlorate.

Powder these to the consistency of face powder, and heat gently to drive off all

moisture.

Now, melt five parts Vaseline with five parts wax. Dissolve this in white gasoline

(camp stove gasoline), and pour this liquid on 90 parts potassium chlorate (the

powdered crystals from above) into a plastic bowl. Knead this liquid into the

potassium chlorate until intimately mixed. Allow all gasoline to evaporate.

Finally, place this explosive into a cool, dry place. Avoid friction, sulfur,

sulfides, and phosphorous compounds. This explosive is best molded to the desired

shape and density of 1.3 grams in a cube and dipped in wax until water proof. These

block type charges guarantee the highest detonation velocity. Also, a blasting cap

of at least a 3 grade must be used.

The presence of the afore mentioned compounds (sulfur, sulfides, etc.) results in

mixtures that are or can become highly sensitive and will possibly decompose

explosively while in storage. You should never store homemade explosives, and you

must use EXTREME caution at all times while performing the processes in this

article.

You may obtain a catalog of other subject of this nature by writing:

Information Publishing Co.

Box 10042

Odessa, Texas 79762

7. Solidox Bombs by The Jolly Roger

Most people are not aware that a volatile, extremely explosive chemical can be

bought over the counter: Solidox.

Solidox comes in an aluminum can containing 6 grey sticks, and can be bought at K-

Mart, and various hardware supply shops for around $7.00. Solidox is used in

welding applications as an oxidizing agent for the hot flame needed to melt metal.

The most active ingredient in Solidox is potassium chlorate, a filler used in many

military applications in the WWII era.

Since Solidox is literally what the name says: SOLID OXygen, you must have an

energy source for an explosion. The most common and readily available energy source

is common household sugar, or sucrose. In theory, glucose would be the purest

energy source, but it is hard to find a solid supply of glucose.

Making the mixture:

1.Open the can of Solidox, and remove all 6 sticks. One by one, grind up each of

the sticks (preferably with a mortar and pestle) into the finest powder possible.

2.The ratio for mixing the sugar with the Solidox is 1:1, so weigh the Solidox

powder, and grind up the equivalent amount of sugar.

3.Mix equivalent amounts of Solidox powder, and sugar in a 1:1 ratio.

It is just that simple! You now have an extremely powerful substance that can be

used in a variety of applications. A word of caution: be EXTREMELY careful in the

entire process. Avoid friction, heat, and flame. A few years back, a teenager I

knew blew 4 fingers off while trying to make a pipe bomb with Solidox. You have

been warned!

How to make a COý bomb by the Jolly Roger

You will have to use up the cartridge first by either shooting it or whatever. With

a nail, force a hole bigger so as to allow the powder and wick to fit in easily.

Fill the cartridge with black powder and pack it in there real good by tapping the

bottom of the cartridge on a hard surface (I said TAP not SLAM!). Insert a fuse. I

recommend a good water-proof cannon fuse, or an m-80 type fuse,

but firecracker fuses work, if you can run like a black man runs from the cops

after raping a white girl.) Now, light it and run like hell! It does wonders for a

row of mailboxes (like the ones in apartment complexes), a car (place under the gas

tank), a picture window (place on window sill), a phone booth (place right under

the phone), or any other devious place. This thing throws shrapnel, and can make

quit a mess!!

10. Thermite II by Jolly Roger

Thermite is nasty shit. Here is a good and easy way to make it. The first step is

to get some iron-oxide (which is RUST!). Here is a good way to make large

quantities in a short time:

Get a DC converter like the one used on a train set. Cut the connector off,

separate the wires, and strip them both.

Now you need a jar of water with a tablespoon or so of sodium chloride (which is

SALT!) added to it. This makes the water conductive.

Now insert both wires into the mixture (I am assuming you plugged the converter

in...) and let them sit for five minutes. One of them will start bubbling more than

the other. This is the POSITIVE(+) wire. If you do not do this test right, the

final product will be the opposite (chemically) of rust, which is RUST ACID. You

have no use for this here (although it IS useful!).

Anyway, put the nail tied to the positive wire into the jar. Now put the negative

wire in the other end. Now let it sit overnight and in the morning scrape the rust

off of the nail & repeat until you got a bunch of rust on the bottom of the glass.

Be generous with your rust collection. If you are going through the trouble of

making thermite, you might as well make a lot, right?

Now remove the excess water and pour the crusty solution onto a cookie sheet. Dry

it in the sun for a few hours, or inside overnight. It should be an orange-brown

color (although I have seen it in many different colors! Sometimes the color gets

fucked up, what can I say... but it is still iron oxide!)

Crush the rust into a fine powder and heat it in a cast-iron pot until it is red.

Now mix the pure iron oxide with pure aluminum filings which can be bought or filed

down by hand from an aluminum tube or bar. The ratio or iron oxide to aluminum is 8

grams to 3 grams.

Congrats! You have just made THERMITE! Now, to light it...

Thermite requires a LOT of heat (more than a blow torch!) to ignite. However,

magnesium ribbon (which is sort of hard to find.. call around) will do the trick.

It takes the heat from the burning magnesium to light the thermite.

Now when you see your victim's car, pour a fifty-cent sized pile onto his hood,

stick the ribbon in it, and light the ribbon with the blow torch. Now chuckle as

you watch it burn through the hood, the block, the axle, and the pavement. BE

CAREFUL! The ideal mixtures can vaporize CARBON STEEL! Another idea is to use

thermite to get into pay phone cash boxes.

11. Touch Explosives by the Jolly Roger

This is sort of a mild explosive, but it can be quite dangerous in large

quantities. To make

touch explosive (such as that found in a snap-n-pop, but more powerful), use this

recipe:

Mix iodine crystals into ammonia until the iodine crystals will not dissolve into

the ammonia

anymore. Pour off the excess ammonia and dry out the crystals on a baking sheet the

same way as

you dried the thermite (in other words, just let it sit overnight!).

Be careful now because these crystals are now your touch explosive. Carefully wrap

a bunch in

paper (I mean carefully! Friction sets 'em off!) and throw them around.. pretty

loud, huh? They

are fun to put on someone's chair. Add a small fish sinker to them and they can be

thrown a long

distance (good for crowds, football games, concerts, etc.)

12. Letter Bombs by The Jolly Roger

You will first have to make a mild version of thermite. Use my recipe, but

substitute iron

fillings for rust.

Mix the iron with aluminum fillings in a ratio of 75% aluminum to 25% iron. This

mixture will

burn violently in a closed space (such as an envelope). This bring us to our next

ingredient...

Go to the post office and buy an insulated (padded) envelope. You know, the type

that is double

layered. Separate the layers and place the mild thermite in the main section, where

the letter

would go. Then place magnesium powder in the outer layer. There is your bomb!!

Now to light it... this is the tricky part and hard to explain. Just keep

experimenting until

you get something that works. The fuse is just that touch explosive I have told you

about in

another one of my anarchy files. You might want to wrap it like a long cigarette

and then place

it at the top of the envelope in the outer layer (on top of the powdered

magnesium). When the

touch explosive is torn or even squeezed hard it will ignite the powdered magnesium

(sort of a

flash light) and then it will burn the mild thermite. If the thermite didn't blow

up, it would

at least burn the fuck out of your enemy (it does wonders on human flesh!).

13. Paint Bombs by The Jolly Roger

To make a pain bomb you simply need a metal pain can with a refastenable lid, a

nice bright

color paint (green, pink, purple, or some gross color is perfect!), and a quantity

of dry ice.

Place the paint in the can and then drop the dry ice in. Quickly place the top on

and then run

like hell! With some testing you can time this to a science. It depends on the

ratio of dry ice

to paint to the size of the can to how full it is. If you are really pissed off at

someone, you

could place it on their doorstep, knock on the door, and then run!! Paint will fly

all over the

place!!

Smoke Bombs by the Jolly Roger

Here is the recipe for one hell of a smoke bomb!

4 parts sugar

6 parts potassium nitrate (Salt Peter)

Heat this mixture over a LOW flame until it melts, stirring well. Pour it into a

future

container and, before it solidifies, imbed a few matches into the mixture to use as

fuses.

One pound of this stuff will fill up a whole block with thick, white smoke!

19. Mail Box Bombs by the Jolly Roger

1.Two liter bottle of chlorine (must contain sodium hypochlorate)

2.Small amount of sugar

3.Small amount of water

Mix all three of these in equal amounts to fill about 1/10 of the bottle. Screw on

the lid and

place in a mailbox. It's hard to believe that such a small explosion will literally

rip the

mailbox in half and send it 20 feet into the air! Be careful doing this, though,

because if you

are caught, it is not up to the person whose mailbox you blew up to press charges.

It is up to

the city.

How to make Napalm by the Jolly Roger

Pour some gas into an old bowl, or some kind of container.

Get some styrofoam and put it in the gas, until the gas won't eat anymore. You

should have a

sticky syrup.

Put it on the end of something (don't touch it!!). The unused stuff lasts a long

time!

22. How to make a fertilizer bomb by The Jolly Roger

Ingredients:

Newspaper

Fertilizer (the chemical kind, GREEN THUMB or ORCHO)

Cotton

Diesel fuel

Make a pouch out of the newspaper and put some fertilizer in it. Then put cotton on

top. Soak

the cotton with fuel. Then light and run like you have never ran before! This blows

up 500

square feet so don't do it in an alley!!

23. Tennis Ball Bombs by The Jolly Roger

Ingredients:

Strike anywhere matches

A tennis ball

A nice sharp knife

Duct tape

Break a ton of matchheads off. Then cut a SMALL hole in the tennis ball. Stuff all

of the

matchheads into the ball, until you can't fit any more in. Then tape over it with

duct tape.

Make sure it is real nice and tight! Then, when you see a geek walking down the

street, give it

a good throw. He will have a blast!!

24. Diskette Bombs by The Jolly Roger

You need:

A disk

Scissors

White or blue kitchen matches (they MUST be these colors!)

Clear nail polish

1.Carefully open up the diskette (3«" disks are best for this!)

2.Remove the cotton covering from the inside.

3.Scrape a lot of match powder into a bowl (use a wooden scraper, metal might spark

the

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: