AL15602GBDT2S.PDF
(
13 KB
)
Pobierz
AL15602GBDT2S.PDF
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
MAKE
ALFA ROMEO
MOD.
156*
YEAR.
02
2
nd
sem.
fi
PETROL
DIESEL
X
* Models with original equipment keyless entry system.
ALARM/SIREN
POSITION
Position the compact alarms and the sirens behind the left lateral headlamp.
CENTRAL UNIT POSITION
The modular systems and the modules should be positioned under the dashboard, driver’s side.
POWER SUPPLY
+30:
connect to the general supply wiring at the entrance of the fuse box.
-31:
connect directly to the car body.
IGNITION WIRE
+15/54:
connect to the RED/ORANGE wire located in the 20 way white connector in the front part of the
fuse box. Alternatively, in the wiring harness located under the sill cover, driver’s side.
DIRECTION INDICATORS
Connect to the 1 mm
2
LIGHT BLUE wire in the 20 way white connector and LIGHT BLUE/BLACK in the 12
way connector. These connectors are located in the front part of the fuse box, under the dashboard, drivers
side. Alternatively in the wiring harness under the sill cover, driver’s side.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the BROWN/WHITE wire in the wiring harness coming out of the connector of the central located
behind the glove compartment, passenger’s side.
Front window, passenger’s side:
cut the VIOLET/WHITE wire in the wiring harness coming out of the connector of the central located behind
the glove compartment, passenger’s side.
Rear window, driver’s side:
cut the YELLOW/RED wire in the wiring harness under the sill cover, driver’s side.
Rear window, passenger’s side
:
cut the LIGHT BLUE/GREEN wire in the wiring harness under the sill cover, driver’s side.
ACTIVAT./DEACTIVATION
CONTROLS
Connections antithefts/vehicle
Art. 3800 Vehicle Position
YELLOW/BLACK WHITE/BLACK Pos. nr.1 in the 16 way connector
GREY/BLACK +30 supply in the fuse box
VIOLET +30 supply in the fuse box
ORANGE +30 supply in the fuse box
VIOLET/WHITE +30 supply in the fuse box
ORANGE/WHITE +30 supply in the fuse box
•
For ‘Station Wagon’ vehicles the radio receiver central is placed in the boot behind the plastic
bulkhead, on the passenger’s side wheel house.
•
For ‘Sedan’ vehicles the radio receiver central is placed under the shelf of the rear window (keep off
the cover inside the boot).
IMMOBILISATION POINT 1
Gasoil pump
Cut the BLACK/VIOLET wire coming out of the wiring harness of the inertial switch located under the
driver’s side seat.
IMMOBILISATION POINT 2
Central supply
Cut the ORANGE wire in a connector coming out of the central engine plant located under the dash board,
passenger’s side.
STARTER
+50
: Cut the 2 mm
2
RED/BLACK wire located in the wiring harness coming out of the connector of the
ignition key.
BONNET SWITCH
Install an additional switch on the front headlamp support plate, driver’s side.
DOORS SWITCH
Connect to the WHITE wire temporized lamp at the position nr. 1, in the 16 way black connector coming out
of the central locking unit located behind the passenger’s side glove compartment.
BOOT SWITCH
Connect to the RED wire, at the position nr. 14, in the 16 way black connector coming out of the central
locking unit located behind the passenger’s side glove compartment.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
al15602gbdt2s.doc
Plik z chomika:
szajbus1988
Inne pliki z tego folderu:
AL14597GBB.PDF
(38 KB)
AL14700GBB.PDF
(11 KB)
AL14700GBBT.PDF
(11 KB)
AL14703GBBT.PDF
(21 KB)
AL15600GBD.PDF
(11 KB)
Inne foldery tego chomika:
Zgłoś jeśli
naruszono regulamin